![]() IPA (as it is often called) is also perfect to use for. The IPA in reservoir 2 is typically less saturated than reservoir 1 being that it is used for the second wash cycle. Isopropanol is 99.9 pure and is used to remove resin residues after printing in resin printers. Re-insert the hydrometers, rods, and caps when done Next, you will wipe any residual residue from each reservoir using shop towels and/or the provided cleaning brush Remove the cap from the hydrometer rod and unscrew the rod to remove the component entirely Once the reservoir is drained, pull back the sleeve on the quick connect port to release the connection and remove the tube Placing the clamped end of the hose into a container large enough to hold 2 Liters (this is the maximum threshold in each reservoir) release the clamp and allow the reservoir to completely drain To begin, remove the provided hose from the back of your Pro Wash/DryĬlamp the white clip at the end of the hose and attach the metal end to reservoir 2's quick connect port located on the front of your Pro Wash/Dry Conducting Wash/Dry cycles with saturated resin will not provide you with a clean result, leaving your models sticky.Īs such, we will drain the saturated resin. When the hydrometers float, it indicates that the IPA is saturated with resin. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. Archives
December 2022
Categories |